Dorman 99509 Manuel D'instructions

INSTRUCTIONS
KEYLESS ENTRY
REMOTE
99509
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2024 No reproduction in whole or in part without prior written approval.
99509_Instructions
NOTE: Emergency key blank requires
laser cutting.
NOTE: One programmed remote (with
new battery) that starts vehicle must
be present to program new remotes.
INSTRUCTIONS
STEP 1:
Close all doors, tailgate, hood, windows and
sunroof (if equipped). Enter vehicle through
driver door and close it.
STEP 2:
Insert programming dongle into OBD-II port.
Programmer will beep and the LED will flash
green once to indicate power.
STEP 3:
Turn on vehicle hazard lights. Keep hazard
lights on for this entire procedure.
STEP 4:
Insert a working key and turn ignition to key
on, engine off position.
STEP 5:
Wait for programmer to beep once and flash
green LED once.
STEP 6:
Turn ignition off and remove working key
from ignition.
STEP 7:
Insert new key into ignition. Do not turn key.
Leave ignition off. Programmer will beep and
LED will flash green once.
STEP 8:
Wait while key is programmed. This may
take up to 30 seconds. Programmer will
beep three times and flash green LED once
to indicate successful programming.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 9:
Remove key from ignition and programmer
from OBD-II port. Turn off hazard lights.
STEP 10:
To program additional keys, repeat this
process from Step 2. Make sure to remove
programmer for at least 30 seconds
between each programming event.
STEP 11:
Open windows, exit vehicle, close all doors
and test all functions on each remote.
Ensure each key starts vehicle. If a key does
not function correctly, repeat programming
process from Step 1.
NOTE: If programming is
unsuccessful at any point,
programmer will beep for five
seconds. Unplug the programmer,
wait 30 seconds, and begin this
procedure again from Step 1. If
problem persists, call Technical
Support at 1-866-933-2911.
PAGE 1 OF 3