Dorman 99447 Mode D'emploi

INSTRUCTIONS
KEYLESS ENTRY
REMOTE
99447
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2024 No reproduction in whole or in part without prior written approval.
99447_Instructions
NOTE: One programmed key that starts the vehicle must be present to
program new remotes. This key can be either a copy or an original key.
NOTE: The new key blade must be cut prior to beginning this programming
procedure. A locksmith with laser key cutting abilities will be needed to cut
the transponder key that will start the vehicle.
NOTE: The new remote will not add any functions not already equipped on
the vehicle.
INSTRUCTIONS
STEP 1:
Close all doors, liftgate, hood, windows and sunroof (if equipped). Enter the vehicle
through the driver's door and close it.
STEP 2:
Insert a programmed key into the ignition and turn to the key on, engine off position.
STEP 3:
Turn the key to the off/lock position and remove it.
STEP 4:
Within five seconds, insert the new, properly-cut key into the ignition.
STEP 5:
Turn the ignition to the key on, engine off position.
STEP 6:
The security light on the dashboard will turn off to indicate successful programming
of the new key.
STEP 7:
Remove the key from the ignition to finalize programming and exit programming
mode.
STEP 8:
Repeat steps 1-7 for each additional new key to be programmed.
STEP 9:
Exit vehicle, close all doors, open windows, and test all functions on each remote.
Ensure each key starts the vehicle.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
PAGE 1 OF 3