Dorman 99552 Manuel D'installation

INSTRUCTIONS
KEYLESS ENTRY
REMOTE
99552
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2024 No reproduction in whole or in part without prior written approval.
99552_Instructions
NOTE: This procedure will only
program the remote. Transponder key
blank requires laser cutting for key to
start vehicle.
NOTE: One programmed remote (with
new battery) and key that starts
vehicle must be present to program
new remotes.
INSTRUCTIONS
STEP 1:
Close all doors, trunk/liftgate, hood,
windows and sunroof (if equipped). Enter
vehicle through driver door and close it.
STEP 2:
Insert programming dongle into OBD-II port.
The programmer will beep and the LED will
flash green once to indicate power.
STEP 3:
Insert a working key and turn ignition to key
on, engine off position.
STEP 4:
Wait for programmer to beep twice
and LED to flash orange. This may take up
to 15 seconds.
STEP 5:
Turn ignition off and remove working key.
STEP 6:
Within 10 seconds, insert new key and turn
to key on, engine off position.
STEP 7:
Wait for programmer to beep once and LED
to flash green once. This may take up
to 15 seconds.
STEP 8:
Turn ignition off. Do not remove key.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 9:
Within 10 seconds and using same
new key, turn ignition to key on, engine
off position.
STEP 10:
Wait for programmer to beep once and LED
to flash green once. This may take up
to 15 seconds.
STEP 11:
Turn ignition off. Do not remove key.
STEP 12:
Within 10 seconds and using same
new key, turn ignition to key on, engine
off position.
STEP 13:
Wait while key programs. This may take up
to 30 seconds. Programmer will beep three
times and LED will flash green to indicate
programming is complete and successful.
STEP 14:
Turn ignition off. Remove key from ignition
and programmer from OBD-II port.
STEP 15:
To program additional keys, repeat this
process from Step 2. Make sure to remove
the programmer for at least 30 seconds
between each programming event.
STEP 16:
Open windows, exit vehicle, close all doors
and test all functions on each remote.
Ensure each properly-cut key starts vehicle.
If a key does not function correctly, repeat
programming process from Step 1.
NOTE: If programming is
unsuccessful at any point,
programmer will beep for five
seconds. Unplug programmer, wait
30 seconds and begin this procedure
again from Step 1. If problem
persists, call Technical Support at
1-866-933-2911.
PAGE 1 OF 3