Dorman 99277 Manuel D'instructions

INSTRUCTIONS
KEYLESS ENTRY
REMOTE
99277
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2025 No reproduction in whole or in part without prior written approval.
99277_Instructions_v2
NOTE: This procedure will only
program the remote with integrated
key. Key blade must be cut prior to
this procedure.
NOTE: One programmed remote with
integrated key that starts the vehicle
must be present to program new
remotes.
NOTE: Programming can be affected
by voltage fluctuation. Ensure vehicle
battery voltage of 12.6VDC
is maintained throughout this
entire procedure.
INSTRUCTIONS
STEP 1:
Insert programming dongle into OBD-II port.
STEP 2:
Insert an existing key and turn ignition to on
position without starting vehicle.
STEP 3:
Wait for programmer to beep and flash.
NOTE: Depending on your vehicle,
beep may occur after inserting
working key into ignition or after
turning ignition to on position
without starting vehicle.
STEP 4:
Turn ignition to off position and remove key
from ignition.
STEP 5:
Insert new key and turn ignition to on
position without starting vehicle.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when
attempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 6:
Wait for the programmer to beep once and
flash once.
NOTE: Depending on your vehicle,
the beep may occur after inserting
the new key into the ignition or after
turning it to the on position without
starting the vehicle.
STEP 7:
Wait for programmer to beep three times
and flash to indicate programming is
complete and successful.
STEP 8:
Turn ignition off. Remove key from ignition
and programmer from OBD-II port.
STEP 9:
To program additional keys, repeat this
process from Step 1. Make sure to remove
programmer for at least 30 seconds
between each programming event.
STEP 10:
Open windows, exit vehicle, close all doors
and test all functions on each remote with
integrate key. Ensure each key starts the
vehicle. If a key does not function correctly,
repeat programming process from Step 1.
NOTE: If programming is
unsuccessful at any point, the
programmer will beep for five
seconds. Unplug the programmer,
wait 30 seconds and begin this
procedure again from Step 1. If the
problem persists, call Technical
Support at 1-866-933-2911.
PAGE 1 OF 3