Dorman 902-324 Mode D'emploi

INSTRUCTIONS
BLEND DOOR
REPAIR KIT
902-324
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2023 No reproduction in whole or in part without prior written approval.
902-324_Instructions
NOTE: This installation will convert
blend door to single-zone, if
replacing a dual-zone blend door.
INSTRUCTIONS
STEP 1:
Disconnect negative battery cable.
NOTE: Doing this will prevent
accidental deployment of the airbag,
which you will be working near. In
addition, this will force the blend
door to reset.
STEP 2:
Remove glove compartment and plastic
covering behind glove compartment.
Remove screw in center control panel to the
left of glove compartment below vent, then
pop out right side of center control panel
held in place by panel clips.
STEP 3:
Disconnect wiring harness from top of
actuator motor and move out of the way.
STEP 4:
Remove three screws on actuator motor
and remove actuator motor.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 5:
Under the actuator motor removed in
the previous step, you will see a blend
door linkage rod connected to an arm.
Disconnect the rod and then remove
the arm.
STEP 6:
Remove temperature sensor connector,
if equipped.
STEP 7:
Remove screw holding two halves of
plenum box together. If you removed the
temperature sensor in the previous step,
you will see this screw next to the sensor.
PAGE 1 OF 6