Dorman 926-964 Manuel D'instructions

INSTRUCTIONS
A/C HOSE
ASSEMBLY
926-964
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2024 No reproduction in whole or in part without prior written approval.
926-964_Instructions
REMOVAL
INSTRUCTIONS
STEP 1:
Recover refrigerant from A/C system.
STEP 2:
Disconnect both A/C lines (high side and
low side) at service ports behind engine.
STEP 3:
Raise vehicle.
STEP 4:
Remove rear passenger side wheel and rear
passenger side wheel well cover.
STEP 5:
Disconnect A/C lines from expansion valve
in rear of vehicle.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 6:
If desired, remove original A/C lines from
vehicle. This new A/C hose assembly can be
installed with original lines left in place
or removed.
NOTE: Removal of original lines is
not necessary for this installation.
The following instructions show
installation where original lines
are removed.
INSTALLATION
INSTRUCTIONS
STEP 1:
Pass rear of new low side hose forward of
and above rear passenger wheel well to
expansion valve.
STEP 2:
Connect new hoses to expansion valve
in rear of vehicle and tighten to torque
specification per factory service manual.
STEP 3:
Moving from rear to front of vehicle, install
hoses above frame from rear wheel on
passenger side where space is available.
NOTE: Hoses must not come
in contact with sharp edges,
suspension, exhaust or moving parts.
PAGE 1 OF 6