Dorman 924-714 Manuel D'instructions

924-714
IGNITION LOCK
HOUSING
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2023 No reproduction in whole or in part without prior written approval.
924-714_Tech-Note
After installation is complete, the Passlock sensor must be reprogrammed.
There are two methods to perform the programming procedure:
• A 10-minute procedure which requires a Tech2 tool or scanner and a
Techline terminal, which will guide you through the procedure.
• A 30-minute procedure which does not require the use of any tools.
PASSLOCK RELEARN WITHOUT TOOL
IMPORTANT: Do not remove the key from the ignition during this
procedure. If the key is removed, the procedure will have to be
performed from the beginning.
STEP 1:
Turn the key to the ON position with the engine off.
STEP 2:
Attempt to start the engine, then release the key to ON. The vehicle will
not start.
STEP 3:
Observe the SECURITY light. After approximately 10 minutes, the light will
turn OFF.
STEP 4:
Turn OFF the ignition and wait five seconds.
STEP 5:
Repeat Steps 1 to 4 two more times for a total of 3 cycles/30 minutes. The
vehicle will automatically learn the Passlock Sensor Data Code the next time
the ignition switch is turned from OFF to ON
STEP 6:
Turn the vehicle off and then verify the vehicle is able to start.
STEP 7:
DTCs will clear themselves after 100 ignition cycles.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
PAGE 1 OF 3