Dorman 927-933 Manuel D'instructions

INSTRUCTIONS
CATALYTIC
CONVERTER
THEFT
DETERRENT
SHIELD
927-933
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2023 No reproduction in whole or in part without prior written approval.
927-933_Instructions
KIT CONTENTS
A Front shield
B Rear shield
C Rivet nuts (Qty: 12)
D 20mm security star bolts (Qty: 12)
B
G
D
INSTRUCTIONS
STEP 1:
Remove front center floor brace.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
E Washers (Qty: 12)
F Rivet tool
G Security star tool
Two extra rivet nuts, security star bolts and
washers are included.
C
E
F
STEP 2:
Hold front and rear shields up against
vehicle underside to mark the mounting
points. Use this photo of final installation
as a guide for how shields will mount and
use existing holes to locate. Seven of the
mounting points have existing holes and
three do not. Use a 3/8" drill bit to enlarge
seven existing holes and create holes for the
other three.
PAGE 1 OF 6
A