Dorman 926-149 Manuel D'instructions

926-149
TRANSMISSION
CONDUCTOR PLATE
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2025 No reproduction in whole or in part without prior written approval.
926-149_Tech-Note
INSTALLATION NOTES
Before installing this transmission conductor plate, ensure the included foam gasket is
installed in the proper position.
Foam gasket
When positioning main control lower valve body on two molded leadframe alignment studs,
ensure manual valve is aligned with transmission range sensor on molded leadframe before
installing main control lower valve body
Photo courtesy of A2MAC1
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
PAGE 1 OF 3