Dorman 949-043 Manuel D'instructions

INSTRUCTIONS
AIR SUSPENSION
UPFIT KIT
949-043
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2023 No reproduction in whole or in part without prior written approval.
949-043_Instructions
INSTRUCTIONS
STEP 1:
Raise the vehicle.
NOTE: Refer to the Owner's Manual
for the correct lifting procedure and
use proper lifting equipment only.
STEP 2:
Beginning on left (driver) side of vehicle,
remove bump stop.
STEP 3:
For 2004 to 2008 F-150 models only,
remove stock speed nut that held bump
stop in place.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 4:
For 2004 to 2008 F150 models only, install
included M10 x 1.5 speed nut into bump
stop mounting hole with threads to inside
of frame.
STEP 5:
Attach left-side upper frame mount bracket
(marked with L) onto frame using 3/8" flat
washer and M10-1.5x35 button-head screw.
Mount on frame as shown, with uprights of
bracket flush with frame. Tighten to 38 ft-lb
(52 Nm).
STEP 6:
NOTE: For 2009-2014 models,
proceed to Step 8.
On 2004 to 2008 F150 models only, set
one of the lower brackets on axle and axle
spacer/jounce bumper strike plate. Insert
four 3/8"-16x7 1/2" carriage bolts into
inside square holes in bottom bracket.
Brake lines and hoses should be routed
clear of this area.
NOTE: The bracket must nest
between the stock U-bolts that hold
the leaf spring to the axle.
PAGE 1 OF 9