Dorman TB96259RD Manuel D'instructions

INSTRUCTIONS
SUSPENSION
TRACK BAR
TB96259RD
A
B C D
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2023 No reproduction in whole or in part without prior written approval.
TB96259RD_Instructions
KIT CONTENTS:
A Track bar
B Washer
C M12 × 45 mm bolt
D M10 × 50 mm bolt
E M10 × 68 mm bolt
F M12 × 80 mm bolt
G Support bracket
NOTE: This part features an
alternative design to the OE that fits
vehicles with a small lift.
INSTRUCTIONS
STEP 1:
Raise vehicle and remove front wheels.
STEP 2:
G
E F
Remove track bar.
STEP 3:
Use angle
grinder to
remove
flash, debris,
and heavy
corrosion
from inboard
side of track
bar mounting
bracket.
Install track bar relocation bracket onto
OEM track bar mounting area using supplied
M12 × 45 mm bolt. Ensure there is a flush
mounting surface between both brackets. It
may be necessary to grind flash, debris, or
heavy corrosion from the track bar mounting
area to achieve a flush fit. Tighten M12 bolt
to 65 lbs-ft (88 N-m).
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 3 (CONT.):
NOTE: This part is different from
original equipment. Track bar
relocation is designed to help
vehicle stability.
NOTE: If track bar removed from
vehicle does not use a tapered
stud, mounting hole diameter must
be checked prior to installation. If
top side of mounting hole exceeds
9/16" (14.3 mm) diameter, consult
a certified technician for modified
installation instructions.
STEP 4:
Using a 7/16" bit, drill a hole through the
relocation bracket hole and into OEM track
bar mounting bracket. Use the hole in the
relocation bracket as a guide.
STEP 5:
Install the supplied M10 × 50 mm bolt to
secure the relocation bracket using the hole
just created. Attach corresponding nut and
tighten to 55 lbs-ft (75 N-m).
PAGE 1 OF 6