Dorman 926-965 Instructions

INSTRUCTIONS
A/C HOSE
ASSEMBLY
926-965
A B C
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2025 No reproduction in whole or in part without prior written approval.
926-965_Instructions
KIT CONTENTS
A Rear line section
B Middle line section
C Front line section
D Heat shield
REMOVAL
INSTRUCTIONS
STEP 1:
Remove airbox assembly.
STEP 2:
Recover refrigerant.
STEP 3:
Raise vehicle.
STEP 4:
Drain coolant.
STEP 5:
Lower or remove center section of exhaust.
NOTE: It is only necessary to lower, not
D
remove, center and rear sections of
exhaust. However, exhaust assembly can
be removed to improve access.
STEP 6:
Support rear axle and remove passenger side rear
shock and shock bracket. Do not lower axle.
STEP 7:
Lower or remove rear section of exhaust.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: It is impossible in these instructions to account for all possible circumstances or situations that you may experience when at-
tempting to install this product. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 8:
Disconnect A/C lines from expansion valve in rear
of vehicle.
STEP 9:
Disconnect rear A/C lines and heater core hoses
and drain coolant.
STEP 10:
Disconnect front A/C lines and heater core hoses
and drain coolant.
STEP 11:
Remove midship and rear A/C and heater core
hoses.
PAGE 1 OF 6