Electrical; Electrical Connection; Breaker Size; Electrical Wire Size - Waterco Electroheat PRO Guide D'utilisation

INSTALLATION INSTRUCTIONS
IMPORTANT

Electrical

To ensure your safety and ensure the adequate functioning of your pool heat pump, all
electrical work should be performed by a fully qualified and licensed electrician in
accordance with local electrical codes.
An adequate circuit breaker and copper wiring must be used. This information is available
on the name plate of the pool heat pump. It may be necessary to install a ground circuit
breaker.
!
WARNING

Electrical Connection

Standard 60 Hz power supply : 208/240 v - 60Hz-1 phase
Standard 50 Hz power supply : 208/240 v - 50Hz-1 phase
3 phase power supply

Breaker Size

Please consult the name plate on the base or the side of your pool heat pump for running
amperage and required breaker size.

Electrical Wire Size

Please consult a qualified and licensed electrician.
!
WARNING
The power cable ground must be connected to the electrical panel and to the ground
lug of the pool heat pump. An improper installation may be a potential cause of fire,
electrical shock or injury.
: 200/230 v - 50/60 Hz - 3 phase
380/420 v - 50/60 Hz - 3 phase
Pool Heat Pump I pg 08