To Start The Pool Heat Pump; To Stop The Pool Heat Pump; To Check And Adjust Temperature Settings - Waterco Electroheat PRO Guide D'utilisation

OPERATION OF YOUR POOL HEAT PUMP

To Start the Pool Heat Pump

Press the button ON/OFF on the electronic control to start the pool heat pump. The
temperature display shows the pool water temperature flowing in your pool heat pump and
the fan motor starts (fan blades turn) but the compressor does not start.
The temperature display flashes until the compressor starts and when the timer will
complete its cycle of 3 to 5 minutes. After 5 minutes, the compressor starts and the
temperature on the display stops flashing.
You can now program the desired temperature for the pool water.

To Stop the Pool Heat Pump

The pool heat pump can be stopped by pressing the ON/OFF button once.

To Check and Adjust Temperature Settings

To program the desired water temperature, press BOTH the UP and DOWN arrow keys at
the same time until the temperature displayed changes degree, then release them.
Press the UP or DOWN arrow to program the desired temperature. The temperature setting
will automatically flash and will be saved. The display temperature will be reverting back to
the pool water temperature when all keys remain untouched for 5 seconds.
To change the temperature display from Fahrenheit (˚F) to Celsius (˚C), press the button
˚C/˚F. The led below the ˚F or ˚C will be lit to indicate the current selection.
Note: The pool heat pump will stop working when the programmed temperature is reached.
I pg 12
Pool Heat Pump