How To Program The Multi Function; How To Program The Timer; How To Stop The Timer - Waterco Electroheat PRO Guide D'utilisation

OPERATION OF YOUR POOL HEAT PUMP
How to Program the Multi Function Electronic
Control Timer to Control your Pool Pump Filtration
Note: This option is available on the Smart Energy and Odyssey models only.
The Multi Function electronic control includes an adjustable internal timer which allows to
control the filtration time of the pool pump. This timer allows 6 cycles of filtration during
a day.
Example:
Desired time of filtration: 3 hours / day = 180 minutes / day
Calculation: 180 minutes / day DIVIDED by 6 cycles of filtration / day = 30
Finally, your pool pump will work 6 times a day during 30 minutes. However, if the water
temperature programmed has not been reached, the pool pump will work until it reaches
the programmed water temperature.

How to Program the Timer

1. Press the SET key until FIL is displayed;
2. If you want the pool pump to work continuously; press the UP or DOWN arrow until ON
is displayed;
3. If you want the pool pump to work during a specific period, press the UP or DOWN
arrow until the number of hours per day of the filtration that you desire is displayed (e.g.:
you would like 3 hours / day, the number 3 must appear on the Multi Function electronic
control).
Note: This type of programming FAVOURS the maintaining of the programmed water
temperature rather than the time of filtration.

How to Stop the Timer

Press the SET key until the Multi Function electronic control displays FIL;
If you do not want to use the timer included in the Multi Function control, press the UP or
DOWN arrow until OFF is displayed.
I pg 18
Pool Heat Pump