Usage Of Chemical Products - Waterco Electroheat PRO Guide D'utilisation

GENERAL SAFETY INSTRUCTIONS
!
WARNING
All electrical connections must be carried out by a qualified electrician, according to the
local electrical codes. Always cut off the unit's main power whenever the access panel
is open or removed.
outdoors (unless approved by the manufacturer), while respecting the minimal clearances
needed for proper operation and heating. Please refer to the section "Location" on the
following page.
IMPORTANT
Proper pool chemistry is vital to the longevity of your pool heat pump. Pay a particular
attention to the total alkalinity and total dissolved solids. It is highly recommended
that you have your pool chemistry checked often by an outside independent pool store.
Your pool water chemistry must be maintained at all times, as shown in the table below, to
prevent damage to your pool heat pump.

Usage of Chemical Products

Never add liquid chlorine, granular chlorine or slow dissolving tablets/pucks into the
skimmer basket. This high concentration of chemicals should be avoided.
Water quality standards that must be strictly adhered to*:
DESCRIPTION
PH Level
Chlorine Concentration
Total Alkalinity
Total Dissolved Solids
Calcium Hardness
* Warranty can be voided if not maintained within these ranges.
!
VITAL
MAKE SURE THE INSTALLATION WAS CARRIED OUT ACCORDING TO THE
INSTRUCTIONS OF THIS MANUAL. SEE "INSTALLATION" SECTION.
MAKE SURE YOUR POOL HEAT PUMP WAS PROPERLY GROUNDED AND BONDED.
SEE "BONDING" AND "BONDING DIAGRAM" SECTIONS.
BEFORE ASKING FOR ASSISTANCE OR SERVICE, PLEASE READ CAREFULLY THE
SECTIONS ON "TROUBLESHOOTING" AND "WARRANTY".
It is strongly recommended that the pool heat pump is installed
NORMAL RANGE*
7.4 to 7.8
1.0 to 4.0 PPM
100 to 120 PPM
Below 1800 PPM Reg. Pool
Below 3500 PPM Salt. Pool
200 to 300 PPM
I pg 04
Pool Heat Pump
VERIFY
1 per week
1 per 2-3 days
1 per 2-3 weeks
1 per month
1 per month
1 per month