Operation Of Multi Function; To Start The Pool Heat Pump; To Stop The Pool Heat Pump - Waterco Electroheat PRO Guide D'utilisation

OPERATION OF YOUR POOL HEAT PUMP
Operation of Multi Function Electronic
Control Panel
To toggle
between
functions
The temperature display of the electronic control panel is factory set to show pool water
temperature in degrees FAHRENHEIT. See section "To Select Temperature in ˚C or ˚F", on
the following page.

To Start the Pool Heat Pump

When the pool heat pump is turned ON or after a power shut down; the panel lights up and
either indicates OFF or the temperature of the pool water circulating inside the pool heat
pump.
When the unit is first turned on and water is flowing, the fan motor will start (blades will turn)
followed by the compressor 3 to 5 minutes later (the compressor and fan may start together
when the unit has automatically cycled off for a period of time and then restarts).

To Stop the Pool Heat Pump

The pool heat pump can be stopped by switching off the electrical power supply or by
setting the desired water temperature below 60 ˚F (15 ˚C).
Actual temperature and setting display
Pool Mode
Compressor running
Spa Mode
To lower desired temperature or
to change settings
To raise desired temperature or
to change settings