Electrical Connection Required To - Waterco Electroheat PRO Guide D'utilisation

IMPORTANT
Electrical Connection Required to Use the Integrated
Pool Water Pump Timer of your Pool Heat Pump.
Note: This option is available for Smart Energy and Odyssey models only.
If you wish to use the integrated timer of your pool heat pump; you must warn your
electrician at the time of installation. All electrical work should be performed by a fully
qualified and licensed electrician in accordance with local electrical codes. The pool
pump MUST not consume more than 16 amps.
NOTE: The junction box of the timer does not provide power for the pool pump, but instead
switches the power (which is fed from another source) on and off to control the pump. An
adequate circuit breaker dedicated to the pool pump must be installed with copper wiring
used, in order for the beneficial functions of the timer. It may be necessary to install a
ground fault circuit breaker.
Use the junction box at the base of pool heat pump.
For Smart Energy and Odyssey models only
Wiring colour codes are:
Green : Ground
Black : Input L1
White : Input L2
Orange : Output T1
Red : Output T2
Junction Box
for the Timer
Pool Pump Breaker
Pool Pump