Electrical Connection Of An Automatic; Electrical Connection To An Automation - Waterco Electroheat PRO Guide D'utilisation

OPERATION OF YOUR POOL HEAT PUMP
Electrical Connection of an Automatic Mode for
the Pool and Spa (Smart Energy and Odyssey
Models Only)
The Multi Function electronic control has the ability
to switch from POOL to SPA mode automatically.
This function is used when warm water is directed
towards the SPA. Activation is carried out by using
an external water pressure switch connected to
the SPA water line. This connection must be done
by a qualified technician.
When the electronic control of the pool heat
pump is located inside the electrical box:
wires coming from the pressure switch connected
on the water piping going to the SPA (as shown on
the right) must be connected at the boundaries of
the electronic control of the pool heat pump.
When the electronic control of the pool heat pump is mounted on the front panel of
the unit:
the Orange and Orange-Black wires located inside the electrical box junction of
the pool heat pump, must be connected to the water pressure switch connected on the
water piping going to the SPA.
Electrical Connection to an Automation System to
the Pool (Smart Energy and Odyssey Models Only)
It is possible to carry out the connection of the Multi Function electronic control to an
automation system for models P4 or P8. This type of connection must be done by a
qualified technician to ensure that your warranty will not be voided.
For automation system operation, you will need to set the SPA temperature to maximum 40
˚C (104°F) and the POOL setting to OFF, so that when the automation system calls for heat;
it will activate the SPA mode and starts the pool heat pump.
Note: When calling for a service technician, you will need to mention the installation of this
type of automation system.
Codes
For codes refer to the section titled "Service Analyser codes".
HP
W S DS AS P/S
The 2
SPR2
AC F1 F2 F3
~ ~
LP FL O COMP PUM P 12 0 12