Block Function; Changing The Water In The Boiler - LaCimbali M26 Utilisation Et Installation

BLOCK FUNCTION

When the machine is blocked, a warning message appears
on the display: if the key
on the display are followed, the wash cycle is performed
and the machine is no longer blocked.
For example, if there is a "coffee block", the following
message appears on the display:
GROUP 1 LOCKED
EXECUTE WASHING
The number of the "blocked group" blinks on the display
and depends upon the number of machine groups.
CHANGING THE WATER IN THE BOILER - Procedure to carry out at least once a day
DT version with display. Keep a hot water distributor key
(11) pressed down for approximately 5 seconds.
The following message will be displayed: "WATER CHANGE
...%". The water from the boiler will drain from the hot water
nozzle (20) ( 0 - 70 ca. of the total capacity).
Dispensing will stop automatically.
After the procedure, the machine will return to its normal
functions and the boiler will be re lled with fresch water.
C version / DT version without display. Continuously
dispense hot water (pressing the appropriate button) until
at least 5 liters of water have been used for a machine
with 2 groups, and 8 liters for a machine with 3 groups.
is pressed and the instructions
If the key is pressed, the previous message will be
integrated as shown:
INSERT FILTER HOLDER
When the "INSERT FILTER HOLDER - GROUP 1" message
appears, the block message for Group 1 disappears. The
block messages for groups still to be washed appear in
alternation.
At this point, follow the steps on the previous pages for
the wash cycle.
20
25 EN
GROUP 1
11