Energy Saving Standby; Energy Saving Mode; Forced Switch On - LaCimbali M26 Utilisation Et Installation

only DT version with display
AUTOMATIC SWITCH OFF / SWITCH ON
The machine can be set to switch off and switch on at
programmed times. Consult the "Service time menu"
chapter to set the "ON Time" switch-on time and the "OFF
Time" switch-off time.
When a service time is set, the machine automatically
switches off at the programmed time. During the automatic
switch-off phase, the following message will appear on the
display:
20 September
wednesday
MACHINE OFF
Note. When the machine is working in the automatic
on/off function do not use the general switch
(1) to switch off the machine. If this happens,
the machine will not be able to switch on again
automatically.
The machine switches on automatically at the programmed
timed. The messages displayed and the operations
performed by the machine are the same as those described
in the paragraph "MANUAL POWERING".

ENERGY SAVING STANDBY

When the machine is switched off, it can be set to the

ENERGY SAVING mode.

When this function is enabled, the machine resistance is
not completely disabled and keeps the boiler pressure at
2.9 psi (0.2 bar).
NOTE. If the day after turning off in energy saving mode is
set as "day closed", the machine turns off completely
for 24 hours, and returns to maintaining 2.9 psi (0.2
bar) pressure in the boiler at the end of the closed day.
Please consult the chapter "Service time menu" for setting
this function.
2017
15:18:12
13 EN
ON
1
ENERGY SAVING MODE
The ENERGY SAVING function can also be enabled
manually if you press the key and hold it for several
seconds .
During this phase:
- If the boiler pressure is set at a value exceeding 17 psi
(1.2 bars), the pressure is lowered to 12 psi (0.8 bar)
- If the boiler pressure is set at a value below 17 psi (1.2
bars), the pressure is lowered by
the set value.
Press any dispensing key to exit the ENERGY SAVING
mode and return to the machine work phase.

FORCED SWITCH ON

Press any dispensing key to force the machine on again.
Note. Forcing the machine on does not change the
programmed on/off times.
Note. At this point the machine will remain on until
the next switch off time is reached.
To immediately return the machine to "off" as originally
programmed, switch it off and on again using the general
on-off switch (1).
psi (0.4 bar) below