Device Connection - Creality Cr-Scan Raptor Manuel

1. Adapter installation and connection
Users can select the appropriate conve er according to their
location standards, then press the conve er lock and push the
selected conve er upward until a click is heard. The speci c
operation is as shown below:
3. Note on use
When using the device, wear the lanyard around your wrist
(as shown on the right) to prevent the device from falling
and causing damage as shown right.

05. Device Connection

2. Device connection
1. Inse the USB-C inte ace of the data cable into the device and tighten the thumb screws;
2. Connect the DC power cord female end of the data cable to the DC male end of the adapter;
3. Plug the adapter into the power outlet;
4. Plug the USB-A inte ace of the data cable into the USB3.0 inte ace of the computer;
The speci c operations are as shown below:
USB 3.0
5