Product Information - Creality Cr-Scan Raptor Manuel

2.1 Equipment ove iew
Multi-line laser projector
DOE projector
Color camera
DOE projector
3D scanning camera
Screw hole
USB-C 3.0

03. Product Information

2.2 Button instructions
Two-color supplemental light
Button
2.3 LED
indicator
instructions
Sta /pause scan
LED indicator color
Zoom out
Zoom in
Green always on
Red and ashing
Yellow and ashing
Orange-red always on
Orange always on
Light blue always on
Brightness /
Dark blue always on
Exposure+
Brightness /
Exposure-
* When the distance LED indicator sta s ashing during scanning, it indicates that scan tracking is lost.
The scanner needs to return to the previously scanned area to backtrack and continue scanning.
*When the device is on standby, the LED indicator will enter a breathing state to save power.
Scanner feedback
Press once to sta scanning; press again to pause
scanning; press and hold for at least 3 seconds to end scanning.
Sho press once to increase the Brightness/ exposure time
of the 3D scanning camera by one level;
Sho press once, the 3D scanning camera Brightness /
exposure time will be reduced by one level;
Sho press once, the 3D model will zoom in one level;
Sho press once to zoom out the 3D model by one level;
Status or meaning
The device is operating normally or
the scanning distance is moderate
The device is in an abnormal status
The device is in an upgrading status
The scanning distance is too close
The scanning distance is close
The scanning distance is far
The scanning distance is too far
LED indicator feedback
The middle LED
indicator ashes once
/
/
/
/
Reference color
3