Creality CR-SCAN RAPTOR Manuel page 12

5. Adjust the scanner and the scanned test piece to the appropriate distance,
that is, when the scanner LED indicator is green (as shown on the right),
or when the distance indicator bar on the software inte ace is optimal,
it means the best scanning distance.
Adjust the camera exposure time and laser brightness to an appropriate level,
ensuring that the markers and laser are bright enough but not overexposed.
For beginners, the software's automatic mode can be used. As users become
more pro cient, we recommend manual adjustment.
6. Press the button on the scanner, or click the button on the software inte ace,
keep the scanner pointed at the object to be scanned and sta scanning.
7. Use the scanner to scan the object 360°. When the scan is completed,
press and hold on the scanner for more than 3 seconds, or click on the software
inte ace to complete the scan and pe orm post-processing in the Creality Scan
software to obtain a complete 3D model (it is recommended that the point distance be
set to 0.1mm). The result is as shown on the right:
Note: The above key operations can also be operated in the Creality Scan software. For speci c software operations, please visit: https://wiki.creality.com/en/3d-scanner
9