Creality CR-SCAN RAPTOR Manuel page 13

08. FAQs
1) How to achieve better model details?
① The blue light mode is more precise than the infrared mode;
② Adjust the exposure time of the IR camera during scanning to ensure moderate exposure. Overexposure is shown as red, while underexposure is shown as blue. in blue light mode, you
also need to adjust the appropriate laser intensity;
③ T to maintain the optimal scanning distance. Generally, the closer the scanner is to the object without losing tracking, the better the details.
④ During point cloud optimization, use a smaller point distance; when the object size is small, the point distance can be set to 0.1mm;
⑤ When meshing, ensure that the number of model faces is su ciently large.
For more scanning tips, please visit: https://wiki.creality.com/en/3d-scanner
2) How to scan the bottom of an object?
① Creality Scan software provides a multi-project merging feature, allowing you to obtain the complete model of an object through multiple scans and merging;
② First scan the visible pa to obtain a pa ial model, then ip the object and continue scanning by backtracking to obtain a complete model (this method is only applicable when
the marker points are attached to the su ace of the object).
3) When do I need a scanning pad?
When scanning smaller objects (such as small pa s, small gures, etc.), you can put marker points on the scanning pad and scan in marker point mode.
4) When do I need to use marker point mode?
Blue light mode requires re ective marker points;
Infrared mode: When the su ace of the object does not have rich geometric features, you can stick re ective marker points on the su ace of the object and scan in marker point mode.
5) When do I need to use texture mode?
When the su ace of an object does not have rich geometric features but has rich textures (such as a vase), you can scan it directly in texture mode.
6) When calibration is required?
It needs to be calibrated when it is not being used for a long time (such as 3 months) or when the device experiences a collision.
7) Can I use calibration boards from other models of scanners?
Each calibration card is unique and corresponds to each scanner. They cannot be swapped. When using a calibration board for the rst time, it needs to be scanned once to bind to the
scanner using the QR code on the back. Otherwise, it may a ect calibration accuracy.
8) What should be noted when storing calibration boards?
After each use, please carefully return the calibration board to its box for proper storage. Avoid contamination, scratching, or heavy pressure on the calibration board to prevent loss or
damage.
9) How to pe orm calibration?
Connect the scanner to the computer, open the Creality Scan software, go to the [Device] inte ace, click on [Calibration], and pe orm calibration by following the animated instructions.
10