Maico RLS 45 K Démarrage Rapide page 9

3 Changing air filters
3.1 Changing the air filters in the PP 45
Switch off the mains fuse and secure it against
being switched on again.
Remove the cover.
Separate the bus line.
Pull the slide-in module evenly out
of the wall sleeve by the pull-out
bracket, do not bend or distort.
WARNING when working on a lad-
der. Risk of injury in the event of a
fall. The slide-in module is difficult
to pull out. Make sure that your
footing is secure. Secure the wor-
king area.
Change front air filter.
Change rear air filter.
Push the slide-in module back into
the wall sleeve and connect the
bus line.
Hook the cover at the top of the
housing and swing it downwards
until it engages in the housing.
Switch the mains fuse on.
Acknowledge the filter change on the control.
3.2 Changing the air filters in the PPB 30
WARNING when working on a ladder. Risk of in-
jury in the event of a fall. Make sure that your foo-
ting is secure. Secure the working area.
Switch off the mains fuse and secure it against
being switched on again.
Loosen unit cover. To do so,
lightly push in the two catches, at
the bottom of the cover, with a
pointed object.
Pull the cover forward on the
lower edge and remove it.
Remove both of the used air fil-
ters (→ arrows).
Insert new air filters. Always
change both air filters.
Hook in the cover in the upper
area.
Swing the cover downwards until
both catches engage in the hou-
sing.
Switch the mains fuse on.
Acknowledge the filter change on the room air
control.
9