Maico RLS 45 K Démarrage Rapide page 7

2 Operation, Settings
2.4 Automatic operation: Symbols,
LEDs
To activate, see chapter Switching on automatic
mode [} 7].
RLS 45 K: The symbol LED lights up
when the function is activated.
RLS 45 O: When the function is activa-
ted, the LED for ventilation level 3 lights
up.
Selected with DS 45 RC: When the func-
tion is activated, the symbol LED on the
PP 45 RC/PPB 30 RC lights up (oran-
ge=heat recovery or blue=crosswise).
2.5 Faults: Symbols, LEDs
RLS 45 K fault: The symbol LED lights
up. The vertical LEDs flash quickly and
indicate a fault (fault number depending
on the LED combination of the 3 LEDs)
→ Faults chapter of the operating instruc-
tions.
RLS 45 O fault: The vertical LEDs flash
quickly and indicate a fault (fault number
depending on the LED combination of the
3 LEDs) → Faults chapter of the opera-
ting instructions.
PP 45 RC/PPB 30 RC fault: The red
LED flashes. The fault number is indica-
ted by long and short LED flash combina-
tions → Faults chapter of the operating
instructions.
2.6 Setting the ventilation level
RLS 45 K: Use or
ventilation level. Ventilation system in standby
at level 0 (level 0 can be deactivated in the ser-
vice menu).
RLS 45 O: Use to select the desired ventila-
tion level. Ventilation system in standby at level
0 (can be deactivated in the service menu).
to select the desired
Ventilation level LEDs – Levels 0 to 5
0 1 2
DS 45 RC: Use or
ventilation level. At the bottom of the ventilation
unit, the orange or blue LED lights up x times ac-
cording to the ventilation level, for example 5 ti-
mes for level 5. Ventilation system in standby at
level 0 (level 0 can be deactivated in the service
menu).
Ventilation level LEDs, Levels 0 to 5
0 1 2
LED LED LED
off flashes flashes
1 times 2 times
2.7 Switching on time-limited inten-
sive ventilation (intermittent ventila-
tion)
Press button for 2 seconds. The ventilation
unit runs for 30 minutes at level 5 (duration of in-
termittent ventilation can be parameterised).
2.8 Switching on time-limited switch-
off (sleep function)
Press button for 2 seconds. The ventilation
unit switches off for 60 minutes (duration of
switch-off can be parameterised).
2.9 Switching on automatic mode
The sensor/demand-driven automatic function
is only available when the sensor is connec-
ted and activated. Automatic dehumidification
with HYI or HY sensor. Automatic CO2 and air
quality control with CO2 and VOC sensor. The
air volume is infinitely variable.
3 4 5
to select the desired
(orange or blue)
3 4 5
LED LED LED
flashes flashes flashes
3 times 4 times 5 times
7