Publicité
How to Use
EN
Use Mopping Function
It is recommended that all floors are vacuumed at least three times before
the first mopping session to achieve a better cleaning effect.
1. Dampen the mop pad and wring out excess water. Install the mop pad as
shown in the diagram.
①
2. Fill the tank with water.
Note:
• Do not use detergent or disinfectant.
• Do not fill the water tank with hot water as this may cause the water tank to warp.
12
②
③
3. Align the mopping module as indicated by the arrow, then slide it into
the back of the robot until it clicks into place. Press the power button or use
Dreamehome app to start cleaning.
Click
Note:
• It is not recommended to use the mopping function on carpets.
• Use the app to adjust the water flow as required.
4. When the robot finishes a cleaning task and returns to the charging dock,
remove the mopping module and wash the mop pad in time. To remove the
water tank, slide the two release clips on the side of it to take it out.
Note: When the robot is charging or not in use, remove the mopping
module, pour out all the remaining water in the water tank, and clean the
mop pad to prevent mildew or odors.
Click
Publicité
