Publicité
Routine Maintenance
EN
Main Brush
1. Press the brush guard clips inwards to remove the brush guard and lift
the brush out of the robot.
2. Pull out the brush covers at both ends of the brush as shown in the
diagram. Use the provided cleaning tool to remove any hair tangled in
the brush. Reinstall the brush covers on both ends of the brush, and then
reinstall the brush. Press on the brush guard to lock it in place.
16
Side Brush
Remove and clean the side brush.
Omnidirectional Wheel
Note:
· Use a tool such as a small screwdriver to separate the axle and tire of the
omnidirectional wheel. Do not use excessive force.
· Rinse the omnidirectional wheel under the running water and put it back after
drying it completely.
Publicité
