Operation With Märklin 6021; More Functions; Programming Mode - Roco 41273 Manuel D'utilisation

More functions

We are certain that you noticed when trying the set out that not all of the functions which are described in
GB
the "function overview" are available in the delivery state.
So that more functions can be addressed with the Märklin
on the one hand: the "2
normal address.
Example 1
Address (CV1)=3 (delivery state)
2 address=4
nd
on the other: there is a dedicated function key occupancy (refer to the table on the next page) which
addresses more functions at different addresses (1
activated via CV65 (locomotive) or CV61 (carriage) respectively.
Example 2
Locomotive: addresses 3 (CV1) and 4
Carriage: addresses 5 (CV1) and 6.

Programming mode

Note: programming is only possible if DIP switch #2 on the back of the Märklin
Programming:
1. set the speed controller to '0'
2. press stop+go for approx. 1 sec. in order to trigger reset (or disconnect/connect the Station)
3. press stop
4. enter the address or '80'
5. press go during the activation of the change in the direction of travel
6. enter the CV at Märklin
7. activate the change in the direction of travel
8. enter the value in two figures (1-79 possible, enter '80' for value 0)
9. activate the change in the direction of travel
10. the decoder has been programmed and is in travel mode
34
Digital Waggon.indd 34
Operation with Märklin
address" . This is activated in the delivery state and is one higher than the
nd
6021 in two figures in the form of a locomotive address (CV1-79 possible)
1)
6021
1)
6021, you have
1)
address + 2 address), which can be
st nd
6021 has been activated.
1)
22.10.2008 09:53:13