Operation With A Dcc Command Station; More Functions - Roco SNCF Manuel

▪ Operation with a DCC Command Station (Z21® system / multi MAUS)
As the MULTIMAUS® has 20 function keys and a light button, can be especially comfortably operated.
Programming modes:
The locomotive and carriages react to all DCC programming modes.
We recommend: direct CV programming (byte by byte) or POM mode (programming on main track).
The programming is described in the MULTIMAUS® manual.
Reading CVs:
® ® ®
With the appropriate equipment (e.g. / Z21 / z21 / z21 start), you can read the value byte by byte and bit by bit.

▪ More Functions

You can find out about a range of other possible set-tings, which are probably very rarely needed, relating to drive speed curve, load control
setting or noise synchronization from the detailed handbook. This can be downloaded as a pdf document MX645P22 from www.zimo.at.
30
72808.indd 30 28.06.2019 08:42:34