Operation With A Dcc Command Station (Multimaus / Z21 Wlan-Multimaus ); Programming Modes; More Functions - Roco 85 DB Serie Manuel

CV Name
13 Analogue modes F1 - F8 (00 – no function in analogue
mode)
01 – Function F1
04 – Function F3
16 – Function F5
64 – Function F7
Attention! Several things happen at the same time when se-
veral functions are activated via CV's in analogue operation.
14 Analogue modes F9 - F12
01 – Locomotive headlight (front)
02 – Locomotive headlight (rear)
04 – Function F9 08 – Function F10
16 – Function F11 32 – Function F12
17+ Long address (requirement: corresponding CV29 long
18 address setting is activated)
29 Settings
266 Total Volume of all Sounds
▪ Operation with a DCC Command Station
(multiMAUS / Z21 WLAN-MULTIMAUS
As the (multiMAUS / Z21 WLAN-MULTIMAUS
especially comfortably operated.

Programming modes:

The locomotive and carriages react to all DCC programming modes.
We recommend: direct CV programming (byte by byte) or POM mode (programming on main
track).
The programming is described in the multiMAUS / Z21 WLAN-MULTIMAUS
Reading CVs:
With the appropriate equipment (e.g. / Z21 /z21 / z21start), you can read the value byte by byte
and bit by bit.

▪ More Functions

You can find out about a range of other possible set-tings, which are probably very rarely needed,
relating to drive speed curve, load control setting or noise synchronization from the detailed
handbook. This can be downloaded as a pdf document MX6452P22 from www.zimo.at.
28
28
8072270920.indd 28
02 – Function F2
08 – Function F4
32 – Function F6
128 – Function F8
)
®
) has 20 function keys and a light button, can be
®
Value Default
Value
00 – 255 1
00 – 255 195
100 – 9999
14
00 – 255 64
manual.
®
31.05.2017 06:38:36