Operation With A Dcc Command Station (Multimaus ® ); More Functions; Operation With Märklin 6021; ▪ Programming With Märklin - Roco S 160 CSD Manuel

▪
Operation with a DCC Command Station (MULTIMAUS
As the MULTIMAUS
®
Programming modes:
The locomotive and carriages react to all DCC programming modes.
We recommend: direct CV programming (byte by byte) or POM mode (programming on main track).
The programming is described in the
Reading CVs:
With the appropriate equipment (e.g. Z21 / z21 / z21start), you can read the value byte by byte and bit
by bit.
▪
More Functions
You can find out about a range of other possible set-tings, which are probably very rarely needed, rela-
ting to drive speed curve, load control setting or noise synchronization from the detailed handbook. This
can be downloaded as a pdf document MX645P16 from www.zimo.at
▪
Operating with Märklin
More Functions
We are certain that you noticed when trying the set out that not all of the functions which are described
in the "function key mapping" are available in the delivery state.
So that more functions can be addressed with the Märklin
Example
Address (CV1)=3 (default state)
2 address=4
nd
▪ Programming with Märklin
Note: programming is only possible if DIP switch #2 on the back of the Märklin
1. set the speed controller to '0'
2. press stop+go for approx. 1 sec. in order to trigger reset (or disconnect/connect the Station)
3. press stop
4. enter the address or '80'
5. press go during the activation of the change in the direction of travel
6. enter the CV at Märklin
7. activate the change in the direction of travel
8. enter the value in two figures (1-79 possible, enter '80' for value 0)
▪
Operation with Märklin
Attention!
Only Märklin locomotives are included in the Märklin
1)
For docking Roco Locomotives in the Märklin
36330/37962. They are to be set this way:
8072164920 in Frutiger.indd 21
has 20 function keys and a light button, can be especially comfortably operated.
MULTIMAUS
6021
1)
6021
1)
6021 in two figures in the form of a locomotive address (CV1-79 possible)
1)
Mobile Station
1)
Mobile Station, use one of the two universal numbers
1)
)
®
®
manual.
6021, you have.
1)
Mobile Station Databank.
1)
6021 has been activated.
1)
21.11.2017 14:15:19
21
21