Operation With A Dcc Command Station (Multimaus); Operation With Z21-App; Analog Operation Ac Or Dc; Firmware Update - Roco EDK 750 Manuel

▪ Operation with a DCC Command Station (multiMAUS from Ver. 1.05)
As the multiMAUS has 28 function keys and a light button, can be especially comfortably ope-
rated.
The locomotive and carriages react to all DCC programming modes.
direct CV programming or POM mode (programming on main track).
The programming is described in the multiMAUS, WLANMAUS, Z21 manual.
With the appropriate equipment (e.g. / Z21 / z21 / z21start), you can read the value.
▪
The crane can also be operated with MM-Format control panels with restrictions. However,
only functions F0 to F4 (MM-2) can be used, or functions F0 to F8 if a so-called subsequent
address is used. However, it only makes sense to operate the crane in MM format if you need
to use a control centre that cannot handle DCC itself. DCC is much more powerful and there-
fore absolutely preferable.

▪ Operation with Z21-App

We ask you to update the Z21 application to be able to control it optimally.

▪ Analog operation AC or DC

or DC)! This can damage the crane!
▪
First the crane decoder must be reset using CV8=8.
Then the crane main board is reset using CV908=8.

▪ Firmware Update

The crane decoder and the main board can be updated with black Z21.
The latest version is available on Z21.eu.
▪
This can be downloaded as a pdf document
MM)
MX659 from www.zimo.at.
45
45