Operation With Märklin Mobile Station; Programming With Märklin 6021 - Roco DRB 23 002 Manuel

▪ Operating with Märklin
More Functions
We are certain that you noticed when trying the set out that not all of the functions which are described
in the "function key mapping" are available in the delivery state.
So that more functions can be addressed with the Märklin
Example
Address (CV1)=3 (default state)
2 address=4
nd
▪ Programming with Märklin
Note: programming is only possible if DIP switch #2 on the back of the Märklin
1. set the speed controller to '0'
2. press stop+go for approx. 1 sec. in order to trigger reset (or disconnect/connect the Station)
3. press stop
4. enter the address or '80'
5. press go during the activation of the change in the direction of travel
6. enter the CV at Märklin
7. activate the change in the direction of travel
8. enter the value in two figures (1-79 possible, enter '80' for value 0)
▪ Operation with Märklin
Attention!
Only Märklin locomotives are included in the Märklin
1)
For docking Roco Locomotives in the Märklin
36330/37962. They are to be set this way:
Dock the locomotive in the databank:
1. The knob must be set to 0.
2. Press the ESC button.
3. Turn the knob to the menu option ("New Locomotive").
4. Press the knob.
5. Turn the knob to the menu option ("Databank").
6. Press the knob.
7. Choose one of the two universal numbers with the knob (we recommend starting with 36330)
8. Press the knob
Setting the Correct Address:
1. Press the ESC button
2. Move to menu option (Change Locomotive") with the knob
3. Press the knob.
4. Choose menu option ("Address")
32
32
6021
1)
6021
1)
6021 in two figures in the form of a locomotive address (CV1-79 possible)
1)
Mobile Station
1)
Mobile Station, use one of the two universal numbers
1)
6021, you have
1)
1)
Mobile Station Databank.
1)
6021 has been activated.