Starting Locomotive Operation; Prior To Initial Commissioning; Running The Model In; Operating Instructions - Roco DRB 23 002 Manuel

▪ Prior to initial commissioning

In order to prevent poor running characteristics or damage from occurring, the coupling rod bearings
on your locomotive must be oiled prior to undertaking the initial commissioning. We recommend using
the ROCO oiler 10906

▪ Running the model in

During the first five minutes the locomotive should run at medium speed.

▪ Operating instructions

Only for showcase

▪Fittings

Operation is possible with different couplings. We recommend using the Roco close coupling.

Starting locomotive operation

The smallest radius this model should run is R3
or rather R2 of the Track system (model without
tubes protecting pistons). Your locomotive will
run smoothly on clean tracks only. For this pur-
pose we recommend using item no. 46400, Roco
track cleaning van, or item no. 10002, Roco track
cleaning rubber, for removing heavy dirt.
Optional
21
21