Programming With Märklin Mobile Station - Roco DRB 23 002 Manuel

5. Press the knob.
6. Choose the address of the locomotive
7. Press the knob.
In the case that the locomotive does not run, erase the locomotive from the databank:
1. Press the ESC button
2. Choose the menu option (Erase Locomotive)
3. Press the knob
4. Press the knob again to confirm
Repeat the steps
"Dock the Locomotive in the databank" (1-8) and "Setting the Correct Address" (1-7)
Should there still be problems, delete the locomotive from the databank again.
Repeat the steps
"Dock the Locomotive in the databank" (1-8), except that at step 5 you go to the menu option ("Address"),
and at step 7 you should set the address of your locomotive.
Look for the desired symbol with the knob, and confirm your choice with the knob.
The functions F1 – F4 can be accessed with the 4 left side buttons on the Mobile Station. The top button
is for function F1. However, the activated functions cannot be shown in the display.
▪ Programming with Märklin
1. Press the "ESC" button
2. Rotate to the right "EDIT LOC" --> press OK
3. Rotate 2x to the left to "REG" --> press OK
4. Rotate until the required CV flashes --> press OK
5. Rotate until the required value flashes --> press OK
The locomotive confirms the programming by flashing briefly.
The carriage confirms the programming by the interior lighting flashing and with additional sounds.
1) "Märklin" is the registered trademark of the Gebr. Märklin & Cie. GmbH Göppingen
2) „Motorola" is the registered trademark of the Motorola Inc., Tempe-Phoenix (Arizona/USA)
Mobile Station
1)
33
33