Programming With Märklin Mobile Station - Roco S 160 2255 USATC Serie Mode D'emploi

Dock the locomotive in the databank:
1. The knob must be set to 0.
2. Press the ESC button.
3. Turn the knob to the menu option ("New Locomotive").
4. Press the knob.
5. Turn the knob to the menu option ("Databank").
6. Press the knob.
7. Choose one of the two universal numbers with the knob (we recommend starting with 36330)
8. Press the knob
Setting the Correct Address:
1. Press the ESC button
2. Move to menu option (Change Locomotive") with the knob
3. Press the knob.
4. Choose menu option ("Address")
5. Press the knob.
6. Choose the address of the locomotive
7. Press the knob.
In the case that the locomotive does not run, erase the locomotive from the databank:
1. Press the ESC button
2. Choose the menu option (Erase Locomotive)
3. Press the knob
4. Press the knob again to confirm
Repeat the steps
"Dock the Locomotive in the databank" (1-8) and "Setting the Correct Address" (1-7)
Should there still be problems, delete the locomotive from the databank again.
Repeat the steps
"Dock the Locomotive in the databank" (1-8), except that at step 5 you go to the menu option ("Address"), and at
step 7 you should set the address of your locomotive.
Look for the desired symbol with the knob, and confirm your choice with the knob.
The functions F1 – F4 can be accessed with the 4 left side buttons on the Mobile Station. The top button is for
function F1. However, the activated functions cannot be shown in the display.
▪ Programming with Märklin
1. Press the "ESC" button
2. Rotate to the right "EDIT LOC" --> press OK
3. Rotate 2x to the left to "REG" --> press OK
4. Rotate until the required CV flashes --> press OK
5. Rotate until the required value flashes --> press OK
The locomotive confirms the programming by flashing briefly.
The carriage confirms the programming by the interior lighting flashing and with additional sounds.
22
22
8072150920.indd 22
Mobile Station
1)
01.12.2016 11:27:58