Assembly Ta1100 - Husqvarna 535FBX Manuel D'utilisation

WARNING: Use the correct cutting
attachment. Only use the cutting attachment
with the guards we recommend, refer to
Approved accessories on page 37 .
Cutting attachment guard
The cutting attachment guard prevents a loose object to
eject in the direction of the operator. The guard also
prevents the operator from accidentally touching the
cutting attachment.
Examine the cutting attachment guard for damage and
cracks. Replace if it is damaged or has cracks. Only use
the approved guard for the cutting attachment.
WARNING: Do not use a cutting attachment
without an approved guard. If an incorrect or
defective guard is installed, this can cause
damage to persons.
To assemble the loop handle
1. Put the loop handle onto the shaft, between the
arrows.
2. Put the spacer into the slot of the loop handle.
3. Install the nut, the knob and the screw. Do not
tighten fully.
4. Adjust the product to an applicable operation
position.
5. Tighten the knob.
1301 - 004 - 30.01.2021
Trimmer head
• Only use recommended trimmer heads and trimmer
lines.
• Only use recommended cutting attachments.
• Smaller machines requires small trimmer heads and
vice versa.
• The length of the trimmer line is important. A longer
trimmer line requires greater engine power than a
shorter trimmer line of the same diameter.
• Make sure that the cutter on the trimmer guard is
intact. This cuts the trimmer line to the correct
length.
• Soak the trimmer line in water for a couple of days
before use to increase the life length.

Assembly TA1100

To assemble the cutting attachment
guard and trimmer head
1. Attach the correct cutting attachment guard (A) for
the trimmer head (See,
page 37 ).
2. Put the cutting attachment guard onto the fitting on
the shaft.
3. Secure with the bolt(L).
4. Install the drive disc (B) on the output shaft.
WARNING: Always make
sure the trimmer line is
wound tightly and evenly
around the drum to
prevent harmful vibration.
Approved accessories on
A
B
C
A
35