Assembly 535Fbx - Husqvarna 535FBX Manuel D'utilisation

• Keep the correct depth gauge setting. Obey the
instructions and use the recommended depth gauge
setting.
• Make sure that the saw chain has the correct
tension. If the saw chain is not tight against the guide
bar, the saw chain can derail. An incorrect saw chain
tension increases wear on the guide bar, saw chain
and chain drive sprocket. Refer to
chain on page 27 .
To assemble the engine to the frame
1. Assemble the engine and the frame with the bolt.
Make sure that the heel is put on the correct side of
the stop. Refer to the illustration.
10
•
To tension the

Assembly 535FBX

2. Tighten the nut with the combination wrench to
To assemble the load reducer
1. Attach the bottom part of the load reducer to the
Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. If the saw chain is
not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
approximately 15 Nm.
frame.
1301 - 004 - 30.01.2021