Husqvarna 535FBX Manuel D'utilisation page 11

2. Adjust the bottom part of the load reducer to a
correct work height. Tighten the knob.
3. Install the top part of the load reducer. Tighten the
knob.
To assemble the two-piece shaft
1. Turn the knob to loosen the coupling.
2. Align the tab of the cutting attachment (A) with the
arrow of the coupling (B).
B
3. Carefully push the shaft into the coupling until you
hear a click.
1301 - 004 - 30.01.2021
4. Tighten the knob fully.
To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
A
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the engine is
4. Pull the attachment straight out of the coupling.
coupling.
attached to.
C
11