Husqvarna 535FBX Manuel D'utilisation page 14

To set the product in transport position
1. Loosen the knob and remove the top part of the load
reducer.
2. Attach the top part (B) of the load reducer to the
bottom part (A) of the load reducer.
3. Turn the knob 3 turns or more to loosen the coupling
on the shaft.
14
B
A
4. Push and hold the button (C).
C
5. Hold tight in the end of the shaft that the engine is
attached to.
6. Pull the attachment straight out of the coupling.
7. Install the shaft to the knob on the frame.
8. Wind the cord around the load reducer and the shaft.
Attach the cord to the shaft.
1301 - 004 - 30.01.2021