Installation Procedure; Installing The Heat Shield - Gaggenau VI 491 610 Notice De Montage

Installation Procedure

Installing the heat shield

9
CAUTION
Sharp edges. Use protective gloves when
installing the plate.
For safety reasons, the heat shield must be properly
installed. This prevents components from overheating as
a result of the recirculation of hot air from the cooktop.
The heat shield is the same width as the cooktop. For
shipping, it is screwed to the burner box.
After unpacking the cooktop, unscrew the heat shield.
The heat shield will be able to rotate freely, as shown in
the illustration.
Installation of control console
Note: Only install the appliance in conjunction with the
corresponding control console.
1 Remove the packaging of the control knobs and the
protective film from the light rings.
2 Hold the retaining plate against the front panel from
behind. Stick the control knobs into the holes from
the front and screw it tight from behind with the
nuts. Make sure that the control knobs are correctly
arranged.
3 Screw the control console tight to the retaining
plate using the nuts included.
9