Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
For flush mounting:
10
Installation Procedure
Install Appliance
9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
1
Hold the holding plate against the front panel
from the rear. Insert the control knobs in the
holes from the front and screw it down them from
the rear with the nuts. Pay attention to correct
assignment of the control knobs (see figure).
2
Evenly insert the unit in the cut-out. Press the unit
firmly into the cut-out from above.
Note: The unit must sit firmly in the cut-out and
must not move (e.g. during cleaning). If
necessary, secure strips at the sides in the cut-
out if the cut-out width is at the top tolerance
limit.
Publicité
Table des Matières
