Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Replacing the low-setting nozzles
1
Remove the pan support and all burner parts.
2
Undo the cooktop's fastening screws on the
burners and carefully remove the cooktop in the
upward direction. Unscrew the cover plate over of
the spindles.
3
Remove the locking screw of the spindles
between the control knob and gas valve and
extract the spindles from the gas valve. Remove
the cover plate in front of the gas valve.
4
The low-setting nozzles are located in the gas
valve and are screwed in from the front. Turn the
plastic part on the gas valve so that the recess is
above the respective nozzle. Unscrew the nozzle
and pull it out with a small pair of pliers.
5
Fully screw in the new low-setting nozzles as
detailed in the table of nozzles.
6
Slide the spindles onto the gas valve and firmly
tighten the locking screws. Fit and firmly tighten
the cover plates.
Replacing the main nozzles
1
Detach the securing clips from the burner pipes.
Unscrew the burners and extract the burner
pipes. The electrode can be left connected.
Extract the burners from the burner pipes.
2
Extract the nozzles from the burner pipes by hand
and extract the O-ring.
3
Check correct fitting of the O-ring in the new
main nozzles. Slide the nozzles onto the burner
pipes. Do not bend the burner pipes!
4
Fit the burners onto the burner pipes. Fit the
burners. Screw down the burners.
5
After loosening the screw, adjust the outer
burner's air regulation sleeve to the correct
dimensions (see nozzle table - L1). Tighten the
screw again.
6
By turning or moving it, adjust the inner burner's
air regulation sleeve to the correct dimension
(see nozzle table - L2).
7
Fit the cooktop and screw it down evenly. Fit
burner parts and pot supports, paying attention to
correct positioning.
8
Set the pressure regulator to the correct pressure
(see "Connect gas supply").
13
Publicité
Table des Matières
