Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Combination with appliance cover:
cover VA 440 010 is available separately as a special
accessory. When creating the cut-out, bear in mind
the additional space required for the appliance cover.
Flush installation:
Hole for control knob
The built-in control console can be integrated into the
lower cabinet at drawer level. Panel thickness:
(16 - 26 mm)
The appliance
1
2
5
/
" - 1"
8
If front panel thickness is greater than 1" (26 mm):
Mill out front panel on rear side to the dimensions
3
1
/
" x 12
3
/
" (80 x 310 mm) to the point that the
8
16
thickness doesn't exceed 1" (26 mm).
For flush mounting:
According to the figure, create the drill hole Ø 1
/
" (35 mm) for fixing in place the control knob in
3
8
the front side of the lower cabinet. A drilling
template is included for precise positioning of the
drill hole.
9
Publicité
Table des Matières
