Installation Procedure; Prepare Installation Space; Install Appliance - Gaggenau VG 295 CA Notice De Montage

Installation Procedure

Prepare Installation Space

Create the cut-out in the countertop for one or several
Vario appliances according to the installation diagram.
The angle of of the cut surface to the countertop must
be 90°.
After creating cut-out, remove shavings. Seal cut
surfaces in a heat-resistant manner.
Some solid surface countertops require special
installations. For example, heat reflective tape and
rounded corners may be necessary. Contact the
countertop manufacturer for instructions specific to
your countertop.
Observe minimum distance between appliance
underside and furniture parts of
When installing multiple Vario appliances:
account space requirement for VV 200 connection strip
between the appliances. Appliances can also be
installed in individual cut-outs, bearing in mind a
minimum distance between the appliances of 1
(40 mm).

Install Appliance

9
WARNING
Before you plug in an electrical cord or turn on
power supply, make sure all controls are in the
OFF position.
Air intake from above. No intermediate shelf required.
A minimum clearance between the individual niche of at
least 2" (50 mm) is recommended when VG 295 is fitted
onto other appliances in the Vario cooktops 200 series.
Stovetop clamping range: 1³/
1 Cut out an opening in the countertop according to
the installation drawing. Check the minimum
clearance from the rear wall and the sides of
kitchen units. Seal the edges of the cut-out.
In s t a l la t i o n P r o c e d u r e
P r e p a r e I n s t a l la t i o n S p a c e
3 / " (10 mm).
8
Take into
/ "
9
16
" - 2" (30 - 50 mm).
16
2 Turn the clamp fasteners to the side. Place the gas
hotplate into the cut-out and align it evenly.
3 Tighten all clamp fasteners evenly. Check that the
whole frame lies evenly flat on the countertop.
4 Fit the burner rings, burner lids and pan supports.
5 Connect the appliance to the gas and electricity
supply. The appliance is not operable without
power supply.
6 Test the appliance for correct functioning. There
might be an air pocket in the gas supply line if the
appliance turns off and the indicator lights flash.
Turn all control knobs to 0 and ignite the burner
again.
Note: Fasten the hotplate in the work surface with all of
the clamp fasteners provided. This is the only way to
ensure correct installation.
9