Publicité
Slot 2:
• Indicator LED (slot 2) (2h) illuminates:
– Battery row (front) (19a) is occupied but not active.
• Indicator LED (slot 2) (2h) flashes:
– Battery row (front) (19a) is active.
State of charge indicator (2i)
Each battery (18) in each battery row has its own charge
status indicator (2i). The charge status is divided into four
areas, the charge status for the active battery row is dis-
played in each case:
• Three to four LEDs light up:
– The battery (18) is sufficiently charged.
• One or two LEDs light up:
– Charge the battery (18) when you have the oppor-
tunity.
Indicator LED (fault message) (2k)
The indicator LED (fault message) (2k) flashes red in the
event of the following faults:
• One or more batteries (18) are not inserted correctly.
• Overheating of the battery (18) or the drive.
• Overloading of the battery (18) or the drive.
10.6
Switching the product on/off
(Fig. 18)
Switching on
1. Press and hold the on/off switch (lawnmower) (2b), re-
lease the switch-on interlock (4) and pull the safety
bar (1) backwards.
Switching off
1. Release the safety bar (1).
2. Remove the battery.
CAUTION
After switching off, the product will run on. Wait until the
product has come to a complete stop.
10.7
After mowing
• Check all screws and nuts before the next use. Tight-
en up loose screws.
• Empty the grass collection basket before the next use.
• Please also observe the chapter "Storage".
11 Cleaning and maintenance
WARNING
Have maintenance and repair tasks that are
not described in this operating manual, car-
ried out by a specialist workshop. Use only
original spare parts.
There is a risk of accident! Always carry out
maintenance and cleaning work with the mo-
tor switched off and the mains plug discon-
nected. There is a danger of injury! Let the
Product cool down before all maintenance
and cleaning tasks. Elements of the engine
are hot. There is a danger of injury and burn-
ing!
The product can start unexpectedly and cause injuries.
–
Switch off the product before all cleaning and main-
tenance work.
–
Allow the product to cool down.
–
Remove the battery!
CAUTION
Wear protective gloves when handling the
blades!
11.1
Cleaning
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub the
product clean with a clean cloth* or blow it off with
compressed air* at low pressure. We recommend that
you clean the product directly after every use.
• Ventilation openings must always be free.
• Cleaning with a garden hose is only recommended at
low pressure. A high-pressure cleaner is not suitable
for cleaning the product.
1. Unhook the grass collection basket and brush it out
with a hand brush. You can also roughly clean the
housing of the lawnmower with the sweeper.
2. Clean the underside of the lawnmower with a spatula
and hand brush. The spatula helps to remove coarse
and larger plant debris from the area of the blade (21).
Cleaning the underbody is easier and more thorough
immediately after use. Then dirt and plant residues
are still fresh and can be loosened more easily.
3. Do not use any cleaning products or solvents; they
could attack the plastic parts of the product. Make
sure that no water can penetrate the product interior.
4. Check that the grass ejection is clear of grass resi-
dues and remove these if necessary.
www.scheppach.com
GB | 31
Publicité
