Publicité
USING YOUR HUMIDIFIER (CONT.)
Timer
You can set a timer between 1 and 12 hours.
•
Press
repeatedly to choose a time
in increments of 1 hour. When you stop
pressing
, the display will flash 3
times and the timer will start.
•
The humidifier will automatically power
off once the timer is finished.
•
To cancel a timer, press
until the display reads "-:--".
Auto Mode
Auto Mode uses the humidifier's sensor to
automatically adjust the mist level (or turn it
off) to maintain a humidity level of 55–68%
RH (relative humidity). The humidifier will
run continuously when relative humidity is
below 54% RH and will stop when it reaches
68% RH.
•
Press
to turn Auto Mode on/off.
•
The timer and warm mist settings can be
used with Auto Mode.
•
Changing the mist level or the humidity
level will exit Auto Mode.
This table shows the mist levels that Auto
Mode will use at different relative humidity
levels.
Relative Humidity
< 60%
60–63%
64–67%
> 68%
repeatedly
Mist Level
Mist level 3
Mist level 2
Mist level 1
Automatic Shutoff
Turning Off the Display
The display will automatically dim after 10
seconds of inactivity.
•
To turn off the display, press and hold
for 3 seconds.
•
To turn the display back on, press any
button except
•
You can also press
control to turn the display on/off.
Memory Function
While the humidifier is plugged in, it will
remember your settings (except Timer)
when turned off, and will resume those
settings when turned back on.
Automatic Shutoff
The humidifier will automatically turn off
when all of the water in the tank has been
diffused, or if the tank has been removed
from the base.
will show on the display
(and the rest of the display will turn off) until
more water is added to the water tank, or
until the tank is placed properly back on the
base.
[Figure 3.3]
Figure 3.3
Absorption Pads
The mineral absorption pads help prevent
mineral buildup (scale) inside the humidifier,
especially around the heating plate.
Note:
To purchase more pads, see
page 20.
.
on the remote
EN
13
Publicité
