Publicité
Troubleshooting
Perform only the steps described in these instructions. All further
inspection, maintenance, and repair work must be performed by an
authorized service center or a similarly qualified specialist if you cannot
solve the problem yourself.
Always remove the battery from the tool when troubleshooting, inspecting,
maintaining, or cleaning the tool.
Problem
The tool does not run or
does not run continuously.
The tool does not reach full
power.
Possible Cause
1. The battery is not fully
installed in the tool.
2. The battery pack is not
charged.
3. The battery pack is over
or under the appropriate
temperature range.
4. There is moisture on
the leads of the battery
pack.
5. The battery pack is
damaged.
6. There is another
electrical problem with
the tool.
7. Both the auxiliary
handle switch and the
trigger are not pressed.
1. The speed switch is
in the low speed or
anti-jam position.
2. The battery pack charge
capacity is too low.
3. The air vents are
blocked.
26
Corrective Action
1. Remove and then
replace the battery into
the tool, making sure
that it is fully installed
and latched.
2. Remove the battery
pack from the tool and
charge it.
3. Move the battery pack
to a place where it is
dry and the temperature
is between 5°C (41°F)
and 40°C (104°F).
4. Allow the battery pack
to dry or wipe it dry.
5. Replace the battery
pack.
6. Contact an Authorized
Service Dealer.
7. Press both the trigger
and the auxiliary handle
switch simultaneously.
1. Turn the speed switch to
the high speed position.
2. Remove the battery
pack from the tool and
fully charge the battery
pack.
3. Clean the air vents.
Publicité
